Specialised screws to elegantly fasten mirrors to  walls without additional brackets.

The polished chrome cover head is 12mm wide.

The screw is zinc plated for corrosion resistance with an 8mm head.

• Preferably purchase mirrors with pre-drilled holes.
• Drilling holes in mirrors and glass is difficult if you are not an avid DIY'er.
• The holes in the mirror should be 6mm.

For wood walls:

• Drill 2mm pilot holes (using a metal bit).
• Place the screws through the holes in the mirror, making sure the grommets sit inside the holes.
• Tighten the screws with a screwdriver.
• Take care not fasten the screws too tight as it could cause the mirror to break.
• Screw on the decorative cover caps.

Fastening into a brick wall:

• 6mm pilot holes are required for the wall plugs.
• With the wall plugs in place, press the rubber grommets over the screws so that the screw head sits in the broad side of the grommet.
• Place the screws through the holes in the mirror, making sure the grommets sit inside the holes.
• Tighten the screws with a screwdriver.
• Screw on the decorative cover caps.